 | | Product SKUs (Basismodell) |  |
| AS-4120-RT12E1-F | | SuperServer 4120-RT12E1-F (Black) |
 |
| |
| | Motherboard | |
| Opteron® 6000 Serverboard |
|
| |
| | Processor & Cache | |
| CPU | • | Single 1944-pin Socket G34 |
| | • | Supports one 16/12/8/4-Core |
| | | AMD Opteron™ 6000 Series |
| | | processors |
| | • | HT3.0 Link support |
|
| |
| | System Memory | |
| Memory | • | Eight DIMM sockets |
| Capacity | • | Support up to 128GB DDR3 |
| | | 1333/1066/800 MHz memory |
| | • | Quad channel memory bus |
| | • | Recommended that |
| | | memory are populated in groups of |
| | | four of the same type |
|
| Memory | • | DDR3 1333/1066/800 MHz Registered |
| Type | | ECC Unbuffered ECC/non-ECC SDRAM |
| | | 72-bit, 240-pin gold-plated DIMMs |
|
| DIMM Sizes | • | 1GB, 2GB, 4GB, 8GB, 16GB |
|
| Memory | • | 1.35V or 1.5V |
| Voltage | | |
|
| | | |
| | On-Board Devices | |
| Chipset | • | AMD chipset SR5650 + SP5100 |
|
| SATA (onboard) | • | AMD SP5100 (RAID 0, 1, 10) |
|
| IPMI | • | Support for Intelligent Platform |
| | | Management Interface v.2.0 |
| | • | IPMI 2.0 with virtual media over |
| | | LAN and KVM-over-LAN support |
| | • | Winbond® WPCM450 BMC |
|
| Network | • | Two Intel® 82574L controller, |
| Controllers | | Dual-Port Gigabit Ethernet |
| | • | 10/100/1000BASE-T support |
|
| Graphics | • | Matrox® G200 16MB DDR2 |
|
| Super I/O | • | Winbond 83627 chip |
|
| |
| | Add-On Devices | |
| SAS / SATA RAID | • | High Performance SAS RAID |
| | | Controller 4-Port PCI-E/8x |
| | | with 1.6GHz Dualcore Prozessor |
| | • | RAID 0/1/1E/5/5EE/6/10/JBOD |
| | • | Global Hot Spare Supported |
| | • | 256MB DDR2 Cache |
| | • | 4 internal SAS/SATA HDDs supported |
| | • | Online Capacity Expansion and |
| | | RAID Level Migration |
| | • | Support for SAS expander |
| | • | Battery Pack supported (optional) |
|
| |
| | Add-On Devices (depends on config) | |
| 10 GBE NIC | • | Dual-port Intel 82598EB with two |
| | | CX4 connectors |
| | • | PCI-E x8 (PCI-e Gen 2 Compatible) |
| | | to maximize performance |
| | • | Intel I/O Acceleration Technology |
| | | (I/O AT) for improved CPU utilization |
| | • | Low-latency interrupts |
| | • | 16 Virtual Machine Device queues |
| | | (VMDq) for virtualized environment |
| | • | Direct Cache Access (DCA) to |
| | | eliminate cache misses and reduce |
| | | CPU load |
| | • | Tx/Rx, IP, TCP, and UDP checksum |
| | | offloading (IPv4, IPv6) capabilities |
| | | to increase throughput and lower |
| | | processor utilization |
| | • | Preboot eXecution Environment |
| | | (PXE) support |
| | • | Simple Network Management |
| | | Protocol (SNMP) and Remote |
| | | Network Monitoring (RMON) |
| | | statistic counters |
| | • | iSCSI boot |
| | • | Energy-efficient design |
| | | (maximum 6.5W) |
| | • | OS Support: Windows, Linux, |
| | | VMWare |
|
| 8 Gbit | • | Negotiation: |
| Fibrechannel | | 8/4/2Gbps auto-negotiation |
| | • | IOPS: 200,000 initiator |
| | | and target IOPS per port |
| | • | Class of service: |
| | | Class 2 and 3 |
| | • | Topology: FC-AL, FC-AL2, |
| | | point-to-point, switched fabric |
| | | Protocols |
| | • | FCP-3-SCSI, FC-Tape (FCP-2) |
| | • | Dual 8Gbps Fibre Channel |
| | • | SFP+ with LC-style connector |
| | • | Power consumption: |
| | | 6.2 Watts (typical) |
| | • | APIs: |
| | | SNIA HBA API V2, SMI-S, FDMI |
|
| |
| | Expansion Slots | |
| PCI-Express | • | 2 PCI-E x8 (1x used by controller) |
| | • | 1 PCI-E x4 |
| | • | 3 PCI 3.3V |
|
| |
| | Input / Output | |
| SATA | • | Six Serial ATA ports |
| onboard | • | Six internal SATA HDDs |
| | | supported |
|
| LAN | • | 2x RJ45 LAN port |
| | • | 1x RJ45 dedicated IPMI LAN port |
|
| USB | • | 2x USB rear ports |
| | • | 2x USB on-board |
| | • | 4x USB internal headers |
| | • | Total 8x USB 2.0 Compliant |
|
| VGA | • | 1x VGA Port |
|
| Keyboard / | • | PS/2 keyboard and mouse ports |
| Mouse | | |
|
| Serial Ports/ | • | 1x Fast UART 16550 serial rear port |
| Header | • | 1x Fast UART 16550 serial header |
|
| |
|
| | System BIOS | |
| BIOS Type | • | 16Mb Flash EEPROM with AMI® BIOS |
|
| BIOS | • | Plug and Play (PnP) |
| Features | • | DMI 2.3 |
| | • | PCI 2.2 |
| | • | ACPI 2.0 |
| | • | USB Keyboard Support |
| | • | SMBIOS 2.3 |
|
| |
| | Chassis | |
| Form Factor | • | 2U Chassis |
|
| |
| | Dimensions | |
| Height | • | 89mm |
|
| Width | • | 437mm |
|
| Depth | • | 648mm |
|
| Weight | • | ~27kg (depends on Config) |
|
| Available Colors | • | Black |
|
| |
| | Front Panel | |
| Buttons | • | Power On/Off button |
| | • | System Reset button |
|
| |
| | Drive Bays | |
| Hot-swap Bays | • | 12x 3.5" SAS |
| | | Hot-Swap drive bays |
|
| |
| | System Cooling | |
| Fans | • | 3x 80mm 6300 RPM fans |
| | • | 2x Power Supply Fan |
|
| |
| | SAS Backplane | |
| Features |
| | • | Scalability through cascading |
| | • | 3Gb support |
| | • | Inband SES-2 Enclosure Management |
| | • | SAS support |
| | • | Single input/output connectors |
|
| |
| | Power Supply | |
| 800W (1 + 1) Redundant AC-DC high-efficiency power |
| supply w/ PFC |
|
| AC Voltage | • | 100 - 240V, 60-50Hz, 10 - 4 Amp |
|
| +5V standby | • | 4.0 Amp |
|
| +12V | • | 66.0 Amp |
|
| +5V | • | 30.0 Amp |
|
| +3.3V | • | 24.0 Amp |
|
| -12V | • | 0.6 Amp |
|
| |
| | Management | |
| Software | • | Super Doctor III |
|
| Power | • | ACPI Power Management |
| Configurations | • | Wake-On-LAN (WOL) header |
| | • | Keyboard Wakeup from Soft-Off |
| | • | Power-on mode control for AC |
| | | power loss recovery |
|
| |
| | PC Health Monitoring | |
| CPU | • | Monitors CPU Core Voltages, +1.8V, |
| | | +3.3V, +5V, ±12V, +3.3V Standby, |
| | | VBAT, HT, memory, chipset |
| | • | CPU switching voltage regulator |
|
| FAN | • | Up to 6-fan status tachometer monitoring |
| | • | Up to six 4-pin fan headers |
| | • | Status monitor for speed control |
| | • | 3-pin fan support (w/o speed control) |
| | • | Low noise fan speed control |
| | | (4-pin fan only) |
| | • | Pulse Width Modulated (PWM) fan |
| | | connectors |
|
| Temperature | • | Monitoring for CPU and chassis |
| | | environment |
| | • | CPU thermal trip support |
| | • | Thermal Control for 6x Fan Connectors |
| | • | I2C Temperature Sensing Logic |
|
| LED | • | CPU / System Overheat LED |
| | • | +5V Standby Alert LED |
|
| Other | • | Chassis intrusion detection |
| Features | • | Chassis intrusion header |
|
| |
|
|
|
|
|
Druckfehler, Irrtum und techn. Änderung ohne Ankündigung vorbehalten. Genannte Preise sind empfohlene Verkaufspreise. Stand: 4.1.2013
|
Produkte
Symbolfotos
