| Product SKUs (Basismodell) | |
AS-4420-RTQ4-F | | SuperServer 4420-RTQ6-F (Black) |
|
|
| Motherboard | |
Quad Opteron® 6000 Serverboard |
|
|
| Processor & Cache | |
CPU | • | Quad 1944-pin Socket G34 |
| • | Supports up to four Twelve/ |
| | Eight-Core ready AMD Opteron™ |
| | 6000 Series processors |
| • | HT3.0 Link support |
|
|
| System Memory | |
Memory | • | Thirty-Two DIMM sockets |
Capacity | • | Support up to 512GB DDR3 Reg. ECC |
| | 1333/1066/800 MHz memory or 128GB |
| • | of DDR3 Unb. ECC/non-ECC memory |
| • | Quad channel memory bus |
| • | For Dual or Quad CPUs: Recommended |
| • | that memory be populated equally |
| | in adjacent memory banks |
|
Memory | • | Registered ECC or unb. ECC / |
Type | | non-ECC DDR3 1333/1066/800 MHz |
| | SDRAM 72-bit, 240-pin DIMMs |
|
DIMM Sizes | • | 1GB, 2GB, 4GB, 8GB, 16GB |
|
Memory | • | 1.35V or 1.5V |
Voltage | | |
|
| | |
| On-Board Devices | |
Chipset | • | AMD SR5690/SR5670/SP5100 Chipset |
|
SATA (onboard) | • | AMD SP5100 (RAID 0, 1, 10) |
|
SAS (onboard) | • | LSI 2008 8 port SAS2 controller |
| • | RAID 0, 1, 10 |
| • | Optional: RAID 5 support |
|
IPMI | • | Support for Intelligent Platform |
| | Management Interface v.2.0 |
| • | IPMI 2.0 with virtual media over |
| | LAN and KVM-over-LAN support |
| • | Winbond® WPCM450 BMC |
|
Network | • | Intel® 82576 controller, Dual-Port |
Controllers | | Gigabit Ethernet |
| • | 10/100/1000BASE-T support |
|
Graphics | • | Matrox® G200 16MB DDR2 |
|
Super I/O | • | Winbond 83627 chip |
|
|
| Add-On Devices (depends on config) | |
10 GBE NIC | • | Dual-port Intel 82598EB with two |
| | CX4 connectors |
| • | PCI-E x8 (PCI-e Gen 2 Compatible) |
| | to maximize performance |
| • | Intel I/O Acceleration Technology |
| | (I/O AT) for improved CPU utilization |
| • | Low-latency interrupts |
| • | 16 Virtual Machine Device queues |
| | (VMDq) for virtualized environment |
| • | Direct Cache Access (DCA) to |
| | eliminate cache misses and reduce |
| | CPU load |
| • | Tx/Rx, IP, TCP, and UDP checksum |
| | offloading (IPv4, IPv6) capabilities |
| | to increase throughput and lower |
| | processor utilization |
| • | Preboot eXecution Environment |
| | (PXE) support |
| • | Simple Network Management |
| | Protocol (SNMP) and Remote |
| | Network Monitoring (RMON) |
| | statistic counters |
| • | iSCSI boot |
| • | Energy-efficient design |
| | (maximum 6.5W) |
| • | OS Support: Windows, Linux, |
| | VMWare |
|
8 Gbit | • | Negotiation: |
Fibrechannel | | 8/4/2Gbps auto-negotiation |
| • | IOPS: 200,000 initiator |
| | and target IOPS per port |
| • | Class of service: |
| | Class 2 and 3 |
| • | Topology: FC-AL, FC-AL2, |
| | point-to-point, switched fabric |
| | Protocols |
| • | FCP-3-SCSI, FC-Tape (FCP-2) |
| • | Dual 8Gbps Fibre Channel |
| • | SFP+ with LC-style connector |
| • | Power consumption: |
| | 6.2 Watts (typical) |
| • | APIs: |
| | SNIA HBA API V2, SMI-S, FDMI |
|
|
| Expansion Slots | |
PCI-Express | • | 2x PCI-e 2.0 x16 |
| • | 2x PCI-e 2.0 x8 |
| • | 1x UIO slot |
|
|
| Input / Output | |
SATA | • | Six Serial ATA ports |
(onboard) | • | Six internal SATA HDDs supported |
|
SAS | • | Integrated LSI 2008 SAS2 Controller |
(onboard) | • | Eight Serial Attached SCSI (SAS) ports |
| • | Optional RAID 5 support |
| • | 8x 6Gbps SAS / SATA ports |
| • | 6 internal HDDs supported |
|
LAN | • | 2x RJ45 LAN port |
| • | 1x RJ45 dedicated IPMI LAN port |
|
USB | • | 2x USB rear ports |
| • | 1x USB on-board |
| • | 4x USB internal headers OR |
| | 2x USB internal headers + |
| | 2x USB front ports (optional) |
| • | Total 7x USB 2.0 Compliant |
|
VGA | • | 1x VGA Port |
|
Keyboard / | • | PS/2 keyboard and mouse ports |
Mouse | | |
|
Serial Ports/ | • | 1x Fast UART 16550 serial rear port |
Header | • | 1x Fast UART 16550 serial header OR |
| | 1x Fast UART 16550 serial front port |
|
|
|
| System BIOS | |
BIOS Type | • | 16Mb SPI Flash ROM with AMI® BIOS |
|
BIOS | • | Plug and Play (PnP) |
Features | • | DMI 2.3 |
| • | PCI 2.2 |
| • | ACPI 2.0 |
| • | USB Keyboard Support |
| • | SMBIOS 2.3 |
|
|
| Chassis | |
Form Factor | • | 2U Chassis |
|
|
| Dimensions | |
Height | • | 89mm |
|
Width | • | 437mm |
|
Depth | • | 709mm |
|
Weight | • | ~35kg (depends on Config) |
|
Available Colors | • | Black |
|
|
| Front Panel | |
Buttons | • | Power On/Off button |
| • | System Reset button |
|
LEDs | • | Power LED |
| • | Hard drive activity LED |
| • | 2x Network activity LEDs |
| • | System Overheat LED |
| • | Power fail LED |
|
Ports | • | 2x USB & DB9 COM port |
| | (Optional) |
|
|
| Drive Bays | |
Hot-swap Bays | • | 6x 3.5" SAS / SATA Hot-swap drive |
| | bays |
|
Peripheral Bay | • | 1x Slim DVD Drive Bay |
| • | 1x Slim port tray |
|
|
| Peripheral Drives | |
DVD | • | DVD ROM Drive (optional) |
|
|
| System Cooling | |
Fans | • | 6x 80mm 6500 RPM fans |
| • | 4x Power Supply Fan |
|
|
| SAS / SATA Backplane | |
1x 2U SAS / SATA backplane w/ SES-II |
|
|
| Power Supply | |
1400W high-efficiency power supply with PMBus |
|
AC Voltage | • | 180 - 240V, 50 - 60Hz, 7.2-9.5Amp |
|
+5V standby | • | 6 Amp |
|
+12V | • | 116 Amp |
|
|
| Management | |
Software | • | Super Doctor III |
|
Power | • | ACPI Power Management |
Configurations | • | Wake-On-LAN (WOL) header |
| • | Keyboard Wakeup from Soft-Off |
| • | Power-on mode control for AC |
| | power loss recovery |
|
|
| PC Health Monitoring | |
CPU | • | Monitors CPU Core Voltages, +1.8V, |
| | +3.3V, +5V, ±12V, +3.3V Standby, -12V |
| | Standby, VBAT, HT, memory, chipset |
| • | CPU switching voltage regulator |
|
FAN | • | Up to 9-fan status tachometer monitoring |
| • | Up to nine 4-pin fan headers |
| • | Status monitor for speed control |
| • | 3-pin fan support (w/o speed control) |
| • | Low noise fan speed control |
| | (4-pin fan only) |
| • | Pulse Width Modulated (PWM) fan |
| | connectors |
|
Temperature | • | Monitoring for CPU and chassis |
| | environment |
| • | CPU Thermal Trip Support |
| • | Thermal control for 9x fan connectors |
| • | I2C Temperature Sensing Logic |
|
LED | • | CPU / System Overheat LED |
| • | +5V Standby Alert LED |
|
Other | • | Chassis intrusion detection |
Features | • | Chassis intrusion header |
|
|
|
|
|
|
|
Druckfehler, Irrtum und techn. Änderung ohne Ankündigung vorbehalten. Genannte Preise sind empfohlene Verkaufspreise. Stand: 16.6.2016
|